Liaoning Dongdadongre Electricity Co.,Ltd
Address:Northeastern university in shenyang 128 mailbox
Postalcode:110004
Tel:13940365891
Phone:024-23991026 024-23995486
Fax:024-23913210
Website:www.dddq.com
E-mail:dddq@dddq.com
Hot air curtain machine is made by high speed motor drive tubular or centrifugal wind turbines generate strong airflow, forming a invisible door curtain. Therefore, also known as the wind curtain machine, air curtain, air wind curtain machine, air brake, air door, electric hot air curtain machine is to use the electric heating wind curtain machine.
Hot air curtain machine
A. Can be divided by appearance
Large hot air curtain machine, mainly suitable for shopping malls and industrial and mining enterprises, large energy consumption of the hot air curtain machine, is effective to treat the FengMen small hot air curtain machine: installation height is not more than 3 m, the energy consumption of the hot blast curtain machine is smallerIi.
According to the applicable heat medium can be divided into electric hot air curtain machine: easy to use, no pollution, low cost of installation, affordable, good hot water hot air curtain machine, pipe such as water temperature is higher, the system effect is generally steam hot air curtain machine, steam consumption is larger, restricted by the steam boiler, the best effect
Three. According to the direction of air supply can be divided into supply hot air curtain machine (ld) : on the direction of the wind from top to bottom, is the form most of the hot blast curtain machine side supply hot air curtain machine (side) : horizontal air supply, when the installation height more than 5.5 meters, this form shall be taken four. By using the motor can be divided into tubular air curtain machine, air volume is small, the installation height of 2.8 meters below the axial air curtain machine, air volume is small, the installation height of 3 metres centrifugal sirocco curtain machine, air volume is larger, installation height can be adjusted according to the power of the motor, not more than 5.5 m.